Yaakov,
any particular preference ?
I have allocated as follows:
PW type Description
0x0001 Frame Relay DLCI ( Martini Mode ) 0x0002 ATM AAL5 SDU VCC transport 0x0003 ATM transparent cell transport 0x0004 Ethernet Tagged Mode 0x0005 Ethernet 0x0006 HDLC 0x0007 PPP 0x0008 SONET/SDH Circuit Emulation Service Over MPLS(CEM) [Note1] 0x0009 ATM n-to-one VCC cell transport 0x000A ATM n-to-one VPC cell transport 0x000B IP Layer2 Transport 0x000C ATM one-to-one VCC Cell Mode 0x000D ATM one-to-one VPC Cell Mode 0x000E ATM AAL5 PDU VCC transport 0x000F Frame-Relay Port mode 0x0010 SONET/SDH Circuit Emulation over Packet (CEP) 0x0011 Structure-agnostic E1 over Packet (SAToP) 0x0012 Structure-agnostic T1 (DS1) over Packet (SAToP) 0x0013 Structure-agnostic E3 over Packet (SAToP) 0x0014 Structure-agnostic T3 (DS3) over Packet (SAToP) 0x0015 CESoPSN basic mode 0x0016 TDMoIP AAL1 Mode Structured 0x0017 CESoPSN TDM with CAS 0x0018 TDMoIP AAL1 Mode Structured with CAS 0x0019 Frame Relay DLCI 0x001A TDMoIP AAL1 Mode Unstructured 0x001B TDMoIP AAL2 Mode 0x001C cTCP (RFC1144) Transport Header-compressed Packets 0x001D IPHC (RFC2507) Transport Header-compressed Packets 0x001E cRTP (RFC2508) Transport Header-compressed Packets 0x001F ROHC (RFC3095) Transport Header-compressed Packets 0x0020 eCRTP (RFC3545) Transport Header-compressed Packets
I would like to send out the post-LC version today or tomorrow. Let me know id this is fine.
Luca
Yaakov Stein wrote:
This is the start of Last Call for IANA Allocations for pseudo Wire Edge to Edge Emulation (PWE3)
http://www.ietf.org/internet-drafts/draft-ietf-pwe3-iana-allocation-09.t xt
Once again, there is a problem with the PW types for TDMoIP.
Right now there are 0x0016 TDMoIP basic mode 0x0018 TDMoIP TDM with CAS which were probably allocated in analogy to the CESoPSN case.
However, there is no "basic" mode for TDMoIP, and now that I have dropped the FORMID field (in order to use 0000 in the first CW nibble for all cases) I need the differentiation between the 4 modes described in the TDMoIP draft.
These modes are:
AAL1 mode - unstructured AAL1 mode - structured AAL1 mode - structured with CAS AAL2 mode
The final mode (used for sending SS7 or ISDN PRI signaling) will use 0x0006 allocated for HDLC.
So please allocate 4 PW types as described above.
Y(J)S
_______________________________________________ pwe3 mailing list pwe3 at ietf.org https://www1.ietf.org/mailman/listinfo/pwe3