RE: [PWE3] IANA last call

[Shahram Davari <Shahram_Davari at pmc-sierra.com>]

Thanks. What about Nortel's SONET mode?

-Shahram

> -----Original Message-----
> From: Luca Martini [mailto:lmartini at cisco.com]
> Sent: Friday, June 10, 2005 3:35 PM
> To: Shahram Davari
> Cc: Yaakov Stein; pwe3; Stewart Bryant
> Subject: Re: [PWE3] IANA last call
> 
> 
> Shahram,
> 
> These are from AVT, and Jerry's draft : 
> http://ietf.org/internet-drafts/draft-ash-avt-hc-over-mpls-pro
> tocol-00.txt
> Please keep in mind that the authors of the iana drafts are 
> not policers 
> of the allocation , we are just playing the iana role for now.
> So you you have any comments , please send them to the list.
> 
> Thanks.
> Luca
> 
> 
> 
> Shahram Davari wrote:
> 
> >Hi Luca,
> >
> >Where are the following modes defined?
> >
> >0x0008  SONET/SDH Circuit Emulation Service Over MPLS(CEM) [Note1]
> >0x001C  cTCP (RFC1144) Transport Header-compressed Packets
> >0x001D  IPHC (RFC2507) Transport Header-compressed Packets
> >0x001E  cRTP (RFC2508) Transport Header-compressed Packets
> >0x001F  ROHC (RFC3095) Transport Header-compressed Packets
> >0x0020  eCRTP (RFC3545) Transport Header-compressed Packets
> >
> >Is it possible to add a reference to all items? 
> >
> >Thanks,
> >-Shahram
> >
> >  
> >
> >>-----Original Message-----
> >>From: pwe3-bounces at ietf.org 
> [mailto:pwe3-bounces at ietf.org]On Behalf Of
> >>Luca Martini
> >>Sent: Friday, June 10, 2005 1:15 PM
> >>To: Yaakov Stein
> >>Cc: pwe3; Stewart Bryant
> >>Subject: Re: [PWE3] IANA last call
> >>
> >>
> >>Yaakov,
> >>
> >>any particular preference ?
> >>
> >>I have allocated as follows:
> >>
> >>  PW type Description
> >>
> >>   0x0001  Frame Relay DLCI ( Martini Mode )
> >>   0x0002  ATM AAL5 SDU VCC transport
> >>   0x0003  ATM transparent cell transport
> >>   0x0004  Ethernet Tagged Mode
> >>   0x0005  Ethernet
> >>   0x0006  HDLC
> >>   0x0007  PPP
> >>   0x0008  SONET/SDH Circuit Emulation Service Over 
> MPLS(CEM) [Note1]
> >>   0x0009  ATM n-to-one VCC cell transport
> >>   0x000A  ATM n-to-one VPC cell transport
> >>   0x000B  IP Layer2 Transport
> >>   0x000C  ATM one-to-one VCC Cell Mode
> >>   0x000D  ATM one-to-one VPC Cell Mode
> >>   0x000E  ATM AAL5 PDU VCC transport
> >>   0x000F  Frame-Relay Port mode
> >>   0x0010  SONET/SDH Circuit Emulation over Packet (CEP)
> >>   0x0011  Structure-agnostic E1 over Packet (SAToP)
> >>   0x0012  Structure-agnostic T1 (DS1) over Packet (SAToP)
> >>   0x0013  Structure-agnostic E3 over Packet (SAToP)
> >>   0x0014  Structure-agnostic T3 (DS3) over Packet (SAToP)
> >>   0x0015  CESoPSN basic mode
> >>   0x0016  TDMoIP AAL1 Mode Structured
> >>   0x0017  CESoPSN TDM with CAS
> >>   0x0018  TDMoIP AAL1 Mode Structured with CAS
> >>   0x0019  Frame Relay DLCI
> >>   0x001A  TDMoIP AAL1 Mode Unstructured
> >>   0x001B  TDMoIP AAL2 Mode
> >>   0x001C  cTCP (RFC1144) Transport Header-compressed Packets
> >>   0x001D  IPHC (RFC2507) Transport Header-compressed Packets
> >>   0x001E  cRTP (RFC2508) Transport Header-compressed Packets
> >>   0x001F  ROHC (RFC3095) Transport Header-compressed Packets
> >>   0x0020  eCRTP (RFC3545) Transport Header-compressed Packets
> >>
> >>
> >>I would like to send out the post-LC version today or tomorrow.
> >>Let me know id this is fine.
> >>
> >>Luca
> >>
> >>
> >>Yaakov Stein wrote:
> >>
> >>    
> >>
> >>> 
> >>>
> >>>      
> >>>
> >>>>This is the start of Last Call for
> >>>>IANA Allocations for pseudo Wire Edge to Edge Emulation (PWE3)
> >>>>
> >>>>
> >>>>   
> >>>>
> >>>>        
> >>>>
> >>>http://www.ietf.org/internet-drafts/draft-ietf-pwe3-iana-allo
> >>>      
> >>>
> >cation-09.t
> >  
> >
> >>xt
> >>
> >>Once again, there is a problem with the PW types for TDMoIP.
> >>
> >>Right now there are
> >>    0x0016  TDMoIP basic mode
> >>    0x0018  TDMoIP TDM with CAS
> >>which were probably allocated in analogy to the CESoPSN case.
> >>
> >>However, there is no "basic" mode for TDMoIP,
> >>and now that I have dropped the FORMID field
> >>(in order to use 0000 in the first CW nibble for all cases)
> >>I need the differentiation between the 4 modes described
> >>in the TDMoIP draft.
> >>
> >>These modes are:
> >>
> >>  AAL1 mode - unstructured
> >>  AAL1 mode - structured
> >>  AAL1 mode - structured with CAS
> >>  AAL2 mode
> >>
> >>The final mode (used for sending SS7 or ISDN PRI signaling)
> >>will use 0x0006 allocated for HDLC.
> >>
> >>So please allocate 4 PW types as described above.
> >>
> >>Y(J)S
> >>
> >> 
> >>
> >>    
> >>
> >
> >_______________________________________________
> >pwe3 mailing list
> >pwe3 at ietf.org
> >https://www1.ietf.org/mailman/listinfo/pwe3
> >  
> >
> 

_______________________________________________
pwe3 mailing list
pwe3 at ietf.org
https://www1.ietf.org/mailman/listinfo/pwe3